This AC/DC wall adapter provides a substitute for a 9V battery
to power many of your HiViz.com circuits. The adapter accepts 100-240V input
voltage at 50-60 Hz; output is a regulated 9 VDC.
The power rating is 10 W. The AC plug is a standard 2-pin non-polarized US plug. An adapter may be needed for some countries.
The Multi-Trigger 3+ kit includes the parts for an interrupter photogate cable. A kit for the variable-width type of cable can be purchased separately.
Variable-width photogate cable kit
The PGv kit includes an IR emitter and detector, a 3-ft
length of 3-conductor cable, a 1.5-ft length of hookup wire, heat-shrink tubing, and a 3.5mm stereo connector.
Click image to enlarge
Lid Label for Multi-Trigger 3+
We include the label printed on photo-quality paper together with 2 sheets of adhesive laminate.
Flash Trigger Cable Kit (3.5mm type)
This kit is for preparing a cable to connect the flash output of the Multi-Trigger 3 to a PC jack. The kit includes a PC-type connector for the flash, a 3.5mm mono plug, 3-ft of 2-conductor cable, and heat-shrink tubing. Assembly is required. If your flash unit doesn't have a PC jack but does have a hot shoe, the hot shoe adapter shown to the right can be used together with a flash trigger cable for flash triggering.
If your flash unit is one of the Vivitar models 283, 285HV, or 3700, you'll need a Vivitar PC-1 cord to connect to your flash unit. Click here for one possible source. If you're triggering your flash wirelessly or your flash unit has a 3.5mm synch jack, see this page for 3.5mm cables.
PC cable kit with 3.5mm plug,
unassembled - $4.95
PC flash trigger cable,
Select a flash cable kit $4.95), a hot shoe adapter ($9.95), or a combination of flash cable kit ($13.90). The latter combination saves you $1 over purchasing the items separately.
We provide shutter cables for most camera makes/models for use with our triggers. When you order a shutter cable, we include an extension cable and adapter, if needed, to convert the cable for use with the 3.5mm stereo jack on our triggers.
Select your camera make/model below and note the corresponding ID. If you don't find your model listed, compare the socket on your camera to the photos below. The photos will enlarge by clicking on them. If you are still unable to determine the type of plug that you need, please contact us. If you already have a shutter release and want to convert it for use with our triggers, this page may help.
All shutter cables, which include extension cords and adapters (if needed), are $12.95.
Canon EOS Rebel
series, T/X series, EOS 60D, 70D, 100D, 300D, 350D, 400D, 450D, 500D,
550D, 1000D, Powershot G series; Pentax K10D, K20D, K3, K5, K7
Canon EOS 5D Mark II/III, 10D,
20D, 30D, 40D, 50D, D30, D60, 5D/6D/7D, 1D/1DX, 1D/1DS Mark III,
1D Mark III, 1D Mark IV